{"id":254,"date":"2022-04-05T19:43:45","date_gmt":"2022-04-05T19:43:45","guid":{"rendered":"https:\/\/mitechservices.ca\/MITS\/?page_id=254"},"modified":"2024-01-02T01:04:45","modified_gmt":"2024-01-02T01:04:45","slug":"plc-part-2-programming-codesys","status":"publish","type":"page","link":"https:\/\/mitechservices.ca\/MITS\/mi-learning-plc-fundamentals\/plc-part-2-programming-codesys\/","title":{"rendered":"PLC Part 2 Intro To CODESYS"},"content":{"rendered":"\n

Welcome to the next level in our learning series. The subject is an introduction to CODESYS. This is the software that has been selected for this training because it adheres to the industry standard for PLC programing languages. That makes it a great choice when we progress to learning Ladder Diagram later is the series. What is learned here should be re-applicable when programming other types of PLCs. <\/p>\n\n\n\n

The prerequisite for this material is our first learning series, PLC Part 1 The Fundamentals<\/a>. Something else that may help, take a look at the setup for a DIY PLC Training Station<\/a>. The addressing and I\/O mapping referenced in this series are based on the DIY PLC Training Station<\/a> described. Exercises later in the series are designed to work with the training station described but you can cover a lot of the material using the CODESYS built in simulator if you chose. <\/p>\n\n\n

\n
\"Intro<\/figure>\n<\/div>\n\n\n

To get an idea what’s covered here, take a peek at the table of contents. You’ll see that the beginning is a discussion on why CODESYS is the software selected for this training. At the end you will be learning about PLC addresses and getting ready to move on to actual programming.
<\/p>\n\n\n\n

\n

Table of Contents<\/p>\n